diff --git a/website/docs/software/plugins/serial.md b/website/docs/software/plugins/serial.md
index 04b6c8a8..3cf88279 100644
--- a/website/docs/software/plugins/serial.md
+++ b/website/docs/software/plugins/serial.md
@@ -12,15 +12,15 @@ Default is to use RX GPIO 16 and TX GPIO 17.
 
 ## Basic Usage:
 
-1. Enable the plugin by setting serialplugin_enabled to 1.
-2. Set the pins (serialplugin_rxd / serialplugin_rxd) for your preferred RX and TX GPIO pins. On tbeam boards it is recommend to use:
+1. Enable the plugin by setting `serialplugin_enabled` to `1`.
+2. Set the pins (`serialplugin_rxd` / `serialplugin_rxd`) for your preferred RX and TX GPIO pins. On tbeam boards it is recommend to use:
     * RXD 35
     * TXD 15
-3. Set serialplugin_timeout to the amount of time to wait before we consider your packet as "done".
+3. Set `serialplugin_timeout` to the amount of time to wait before we consider your packet as "done".
 4. (Optional) In SerialPlugin.h set the port to `PortNum_TEXT_MESSAGE_APP`if you want to send messages to/from the general text message channel.
 5. Connect to your device over the serial interface at `38400 8N1`.
 6. Send a packet up to 240 bytes in length. This will get relayed over the mesh network.
-7. (Optional) Set serialplugin_echo to 1 and any message you send out will be echoed back to your device.
+7. (Optional) Set `serialplugin_echo` to `1` and any message you send out will be echoed back to your device.
 
 :::note
 The device must be restarted after the settings have been changed for the plugin to take effect.
@@ -29,6 +29,7 @@ The device must be restarted after the settings have been changed for the plugin
 ## TODO (in this order):
 
 * Define a verbose RX mode to report on mesh and packet infomration.
+
 :::note
 This won't happen any time soon.
 :::