diff --git a/docs/configuration/rak-gpio-mapping.mdx b/docs/configuration/rak-gpio-mapping.mdx
new file mode 100644
index 00000000..528392e3
--- /dev/null
+++ b/docs/configuration/rak-gpio-mapping.mdx
@@ -0,0 +1,32 @@
+---
+id: rak-gpio-mapping
+title: RAK GPIO Pin Mapping
+sidebar_label: RAK GPIO Mapping
+sidebar_position: 5
+---
+
+## RAK GPIO Pin Mapping
+
+The RAK4631 uses symbolic labes for its I/O Pins on the module and baseboard silk screens. The following table shows the mapping of the RAK4631 GPIO pins to the corresponding Arduino pins and the MCU Port numbers.
+
+| RAK Pin | nRF52840 Pin | Arduino GPIO | Remark |
+| ------- | ------------ | ------------ | ------ |
+| IO1 | P0.17 | 17 | used for GPS PPM signal if GPS module is connected |
+| IO2 | P1.02 | 34 | used to power all peripheral modules, not available for user application |
+| IO3 | P0.21 | 21 |
+| IO4 | P0.04 | 4 |
+| IO5 | P0.09 | 9 | The 'User Button' is mapped here. |
+| IO6 | P0.10 | 10 |
+| IO7 | P0.28 | 28 |
+| SW1 | P0.01 | 1 |
+| A0  | P0.04/AIN2 | A2 |
+| A1  | P0.31/AIN7 | A7 |
+| SPI_CS | P0.26 | 26 |
+
+When configuring GPIO pins in your device settings, the Arduino GPIO numbers should be used.
+
+```shell title="Example"
+meshtastic --set external_notification.output 10
+```
+This will use IO6 on a RAK4631
+
diff --git a/docs/configuration/remote-admin.mdx b/docs/configuration/remote-admin.mdx
index 03c12270..2ba4050d 100644
--- a/docs/configuration/remote-admin.mdx
+++ b/docs/configuration/remote-admin.mdx
@@ -2,6 +2,7 @@
 id: remote-admin
 title: Remote Node Administration
 sidebar_label: Remote Nodes
+sidebar_position: 4
 ---
 
 :::caution Disclaimer