Remove duplicate warnings

This commit is contained in:
Garth Vander Houwen 2022-07-14 22:29:59 -07:00
parent 5a773d4d7c
commit dcc10e883b
3 changed files with 12 additions and 19 deletions

View file

@ -189,6 +189,12 @@ No canned message test module config options are available in the Web UI.
</TabItem>
</Tabs>
:::warning
GPIO access is fundamentally dangerous because invalid options can physically damage or destroy your hardware. Ensure that you fully understand the schematic for your particular device before trying this as we do not offer a warranty. Use at your own risk.
This module requires attaching a peripheral accessory to your device. It will not work without one.
:::
## Hardware
To navigate through messages and select one, you will require some hardware attached to your device. Currently, the module is tested with a generic rotary encoder, but this is not a limitation further input methods can be added in the future.
@ -257,10 +263,3 @@ meshtastic --set rotary1_enabled True
That's it! With a functioning and enabled rotary encoder, you're ready to begin configuring the Canned Message Module.
:::tip
Once module settings are changed, a **reset** is required for them to take effect.
:::
:::warning
GPIO access is fundamentally dangerous because invalid options can physically damage or destroy your hardware. Ensure that you fully understand the schematic for your particular device before trying this as we do not offer a warranty. Use at your own risk.
:::

View file

@ -123,10 +123,6 @@ External Notification module config is not available for the Web UI.
</TabItem>
</Tabs>
:::tip
Once module settings are changed, a **reset** is required for them to take effect.
:::
:::warning
GPIO access is fundamentally dangerous because invalid options can physically damage or destroy your hardware. Ensure that you fully understand the schematic for your particular device before trying this as we do not offer a warranty. Use at your own risk.

View file

@ -11,14 +11,6 @@ The serial module config options are: Enabled, Echo, Mode, Receive GPIO, Transmi
This is a simple interface to send messages over the mesh network by sending strings over a serial port. Anything you send the node will be turned into a message sent out over the mesh, and anything received from the mesh will be sent to the serial port. Note that this module does not (yet) allow arbitrary protobuf commands to be sent over the serial connection.
:::warning
GPIO access is fundamentally dangerous because invalid options can physically damage or destroy your hardware. Ensure that you fully understand the schematic for your particular device before trying this as we do not offer a warranty. Use at your own risk.
:::
:::note
This module requires attaching a peripheral accessory to your device. It will not work without one.
:::
## Serial Module Config Values
### Enabled
@ -145,6 +137,12 @@ No serial test module config options are available in the Web UI.
</TabItem>
</Tabs>
:::warning
GPIO access is fundamentally dangerous because invalid options can physically damage or destroy your hardware. Ensure that you fully understand the schematic for your particular device before trying this as we do not offer a warranty. Use at your own risk.
This module requires attaching a peripheral accessory to your device. It will not work without one.
:::
## Examples
Default is to use RX GPIO 16 and TX GPIO 17.