---
id: test-serial-driver-installation
title: Test Serial Driver Installation
sidebar_label: Test Serial Driver Installation
sidebar_position: 3
---

import Link from "@docusaurus/Link";
import Tabs from "@theme/Tabs";
import TabItem from "@theme/TabItem";

### Test Serial Driver Installation

You can verify that you have a proper data cable (rather than a charge-only type cable) and that the appropriate drivers for your system are installed by performing the following test:

<Tabs
groupId="operating-system"
defaultValue="linux"
values={[
{label: 'Linux', value: 'linux'},
{label: 'macOS', value: 'macos'},
{label: 'Windows', value: 'windows'},
]}>
<TabItem value="linux">

1. Connect your Meshtastic device to your USB port
2. Open a **Terminal** and enter the following command:

   ```shell
   lsusb
   ```

3. You should see something like:

   ```shell
   ID xxxx:xxxx Silicon Labs CP210x UART Bridge
   # or
   ID xxxx:xxxx QinHeng Electronics USB Single Serial
   # or
   FIXME (WISBLOCK OUTPUT)
   ```

</TabItem>
<TabItem value="macos">

1. Navigate to `Apple Menu  > About This Mac > System Report... > Hardware > USB`.
2. You should see similar to one of the following entries:

- `CP210X USB to UART Bridge Controller`
- `CH9102 USB to UART Bridge Controller`
- `WisCore RAK4631 Board`

</TabItem>
<TabItem value="windows">

1. Navigate to `Device Manager > Ports (COM & LPT)`
2. You should see similar to one of the following entries:

- `Silicon Labs CP210X USB to UART Bridge (COM5)`
- `Silicon Labs CH9102 USB to UART Bridge (COM5)`
- `FIXME (WISBLOCK OUTPUT)`

</TabItem>
</Tabs>

:::info

If you are unable to see your device:

- Make sure that your cable is not only for charging but also for [data transfer](/docs/getting-started/#verify-data-cable).
- It's possible that you need to [reinstall the USB serial driver](/docs/getting-started/serial-drivers).

:::

## Flash Firmware

After completing the previous steps, you can now flash the Meshtastic firmware onto your device. To proceed, select the appropriate device type for your device.

<div className="indexCtasBody">
  <div className="split-container">
    <div className="split-item">
      <Link
        className={"button button--outline button--lg cta--button"}
        to={"/docs/getting-started/flashing-firmware/esp32/"}
      >
        Flash ESP32 Firmware
      </Link>
    </div>

  <div className="split-item">
      <Link
        className={"button button--outline button--lg cta--button"}
        to={"/docs/getting-started/flashing-firmware/nrf52/"}
      >
        Flash nRF52 Firmware
      </Link>
    </div>
  </div>
</div>