meshtastic/docs/hardware/antenna/non-aerial.mdx
apt105 08391be685 Tidying up hardware section
The custom.css changes have changed the behaviour of list items, removing the top & bottom margins, so hopefully looking more like a list and less like a group of items spread across the page.
2022-04-23 00:09:23 +01:00

29 lines
2.6 KiB
Plaintext
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

---
id: non-aerial
title: Non-aerial factors affecting transmission
sidebar_label: Non-aerial factors
slug: /hardware/non-aerial
sidebar_position: 2
---
Unless you're using your devices in a vacuum, with clear line of sight between aerials the following will have an effect:
- Weather (temperature, humidity, and air pressure),
- Transmission power, bandwidth, spreading factor, and other associated channel factors,
- Number of nodes within reach of the mesh (affects retries consequent duty cycle hit),
- Absorption by materials (with varying degrees attenuation, by material and depth),
- Reflection off surfaces (and channeling through material tunnels, including warm / cold air tunnels commonly present in the atmosphere),
- Diffraction around obstacles (over forests and around corners).
- [Fresnel Zone](They may not have been selected for your given frequency range, tuned or of a quality design.) - Football shape between antennas that must be clear of obstructions or else the signal is attenuated.
### Environmental factors
For a bit of light reading on environmental research:
- [RF attenuation in vegetation](https://web.archive.org/web/20201216041455/https://www.itu.int/dms_pubrec/itu-r/rec/p/R-REC-P.833-9-201609-I!!PDF-E.pdf) (yes really); if you wander through the woods wondering how your RF is bouncing off leaves dependent on their variety, and wind speed … well you do, now.
- [RF attenuation with various building materials](https://www.ofcom.org.uk/__data/assets/pdf_file/0016/84022/building_materials_and_propagation.pdf).
- This one by ITU again is very detailed in its [analysis of the drivers of attenuation](https://web.archive.org/web/20211005174833/https://www.itu.int/dms_pubrec/itu-r/rec/p/R-REC-P.2040-1-201507-I!!PDF-E.pdf) (I wasnt aware that all EMF radiation exhibits reflection / transmission characteristics akin to light hitting a material boundary. So, depending on the angle of incidence, material and the EMF wavelength, it will be reflected and / or transmitted through).
- These RF bands are also made more [noisy by adjacent LTE](https://www.ofcom.org.uk/__data/assets/pdf_file/0023/55922/lte-coexistence.pdf)
In summary - wavelengths in Europe fair well in plain sight, curve over not-so-tall obstacles (including trees), and they reflect off surfaces at low angles of incidence. They go through humans without much attenuation; but not brick, stone, or anything with more attenuation than glass / Kevlar. Oh, and dont sit under an LTE tower and expect it to be plain sailing. RF emissions at adjacent frequencies can interfere at a high enough power.