mirror of
https://github.com/meshtastic/meshtastic.git
synced 2024-09-20 16:17:33 -07:00
27 lines
5 KiB
Plaintext
27 lines
5 KiB
Plaintext
---
|
|
id: module-config
|
|
title: Module Configuration
|
|
sidebar_label: Module Config
|
|
sidebar_position: 2
|
|
slug: /configuration/module
|
|
---
|
|
|
|
Modules are included in the firmware and allow users to extend the functionality of their mesh or device.
|
|
|
|
| Name | Description |
|
|
| :------------------------------------------------------------------------: | :---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------: |
|
|
| [Ambient Lighting](/docs/configuration/module/ambient-lighting) | Adjust the brightness of NCP5623 I2C RGB LEDs |
|
|
| [Audio](/docs/configuration/module/audio) | Enable Support for Codec2 Voice Comms on certain devices. |
|
|
| [Canned Message](/docs/configuration/module/canned-message) | Set a number of predefined messages to send out directly from the device with the use of an input device like a rotary encoder. |
|
|
| [Detection Sensor](/docs/configuration/module/detection-sensor) | Configure a GPIO pin to be monitored for specified high/low status and send text alerts. |
|
|
| [External Notification](/docs/configuration/module/external-notification) | Incoming messages are able to alert you using circuits you attach to the device (LEDs, Buzzers, etc). |
|
|
| [MQTT](/docs/configuration/module/mqtt) | Forward packets along to an MQTT server. This allows users on the local mesh to communicate with users on another mesh over the internet. |
|
|
| [Neighbor Info](/docs/configuration/module/neighbor-info) | Send info on 0-hop neighbors to the mesh. |
|
|
| [Paxcounter](/docs/configuration/module/paxcounter) | Count the number of BLE and Wifi devices passing by a node. |
|
|
| [Range Test](/docs/configuration/module/range-test) | Send messages with GPS location at an interval to test the distance your devices can communicate. Requires (at least) one device set up as a sender and one as a receiver. The receiver(s) will log all incoming messages to a CSV. |
|
|
| [Remote Hardware](/docs/configuration/module/remote-hardware) | Set and read a GPIO status remotely over the mesh. |
|
|
| [Serial Module](/docs/configuration/module/serial) | Send messages across the mesh by sending strings over a serial port. |
|
|
| [Store & Forward](/docs/configuration/module/store-and-forward-module) | Stores messages on a device for delivery after disconnected clients rejoin the mesh. |
|
|
| [Telemetry](/docs/configuration/module/telemetry) | Attach sensors to the device and transmit readings on a regular interval to the mesh. |
|
|
| [Traceroute](/docs/configuration/module/traceroute) | Track which nodes are used to hop a message to a certain destination. |
|