2.2 KiB
| id | title | sidebar_label |
|---|---|---|
| environmental-measurement-plugin | Environmental Measurement Plugin Settings | Environmental Measurement Plugin |
Overview
:::caution This is a work in progress and is not yet available. :::
The Environmental Measurement Plugin will allow you to connect climate sensors to report local conditions to your mesh.
Settings
| Setting | Acceptable Values | Default |
|---|---|---|
| environmental_measurement_plugin_measurement_enabled | true, false |
false |
| environmental_measurement_plugin_display_farenheit | true, false |
false |
| environmental_measurement_plugin_read_error_count_threshold | integer |
0 |
| environmental_measurement_plugin_recovery_interval | integer (seconds) |
0 |
| environmental_measurement_plugin_screen_enabled | true, false |
0 |
| environmental_measurement_plugin_sensor_pin | integer |
0 |
| environmental_measurement_plugin_sensor_type | DHT11 |
0 |
| environmental_measurement_plugin_update_interval | integer (seconds) |
0 |
environmental_measurement_plugin_measurement_enabled
Enables the plugin.
environmental_measurement_plugin_display_farenheit
The sensor is always read in Celsius, but the user can opt to view the temperature display in Farenheit using this setting.
environmental_measurement_plugin_read_error_count_threshold
Sometimes sensor reads can fail. If this happens, we will retry a configurable number of attempts Each attempt will be delayed by the minimum required refresh rate for that sensor
environmental_measurement_plugin_recovery_interval
Sometimes we can end up with more than read_error_count_threshold failures. In this case, we will stop trying to read from the sensor for a while. Wait this long until trying to read from the sensor again
environmental_measurement_plugin_screen_enabled
Enable/Disable the environmental measurement plugin on-device display.
environmental_measurement_plugin_sensor_pin
Specify the preferred GPIO Pin for sensor readings.
environmental_measurement_plugin_sensor_type
Specify the sensor type
environmental_measurement_plugin_update_interval
Interval in seconds of how often we should try to send our measurements to the mesh.