mirror of
https://github.com/meshtastic/meshtastic.git
synced 2024-11-14 01:24:14 -08:00
f2e22d63c9
Thanks to aspell and languagetool. Hand picked from these, there are too many strange things in the English language to be perfectly syntactical.
41 lines
1.5 KiB
Markdown
41 lines
1.5 KiB
Markdown
---
|
|
id: serial-plugin
|
|
title: Serial communication plugin
|
|
sidebar_label: Serial communication
|
|
---
|
|
|
|
## About
|
|
|
|
This is a simple interface to send messages over the mesh network by sending strings over a serial port.
|
|
|
|
Default is to use RX GPIO 16 and TX GPIO 17.
|
|
|
|
## Basic Usage:
|
|
|
|
1. Enable the plugin by setting `serialplugin_enabled` to `1`.
|
|
2. Set the pins (`serialplugin_rxd` / `serialplugin_rxd`) for your preferred RX and TX GPIO pins. On tbeam boards it is recommended to use:
|
|
* RXD 35
|
|
* TXD 15
|
|
3. Set `serialplugin_timeout` to the amount of time to wait before we consider your packet as "done".
|
|
4. (Optional) In SerialPlugin.h set the port to `PortNum_TEXT_MESSAGE_APP`if you want to send messages to/from the general text message channel.
|
|
5. Connect to your device over the serial interface at `38400 8N1`.
|
|
6. Send a packet up to 240 bytes in length. This will get relayed over the mesh network.
|
|
7. (Optional) Set `serialplugin_echo` to `1` and any message you send out will be echoed back to your device.
|
|
|
|
:::note
|
|
The device must be restarted after the settings have been changed for the plugin to take effect.
|
|
:::
|
|
|
|
## TODO (in this order):
|
|
|
|
* Define a verbose RX mode to report on mesh and packet information.
|
|
|
|
:::note
|
|
This won't happen any time soon.
|
|
:::
|
|
|
|
## Known Problems
|
|
|
|
* Until the plugin is initialized by the startup sequence, the TX pin is in a floating state. Device connected to that pin may see this as "noise".
|
|
* Will not work on NRF and the Linux device targets.
|